Skip to content

Commercial ยท Offices & retail

Plumbing for offices and retail units

Staff washrooms, a coffee station, a service sink and a small heater in a closet: simple systems that still need to work every single day.

  • Flush valves, sensor taps and urinals repaired
  • Small commercial water heaters serviced or replaced
  • Washroom drains and service sinks cleared
  • Visits before opening so customers never notice
Call (365) 517-7959

Talk to a plumber now.
No forms, no waiting list.

  • Licensed & insured (details on request)
  • Phones answered 7 days a week
  • Oshawa & Durham Region
  • Upfront diagnosis before work
Handwheel valve actuator on a large white supply pipe
A handwheel valve on a building supply riser.

Common calls from plazas and offices

  • Toilet that runs constantly after a flush valve diaphragm wears out
  • Sensor tap that stays on, or never turns on
  • Urinal that overflows or smells
  • Mop sink or service sink backing up
  • No hot water from a closet heater
  • Water stain on a drop ceiling below a washroom

What we check on a visit

  1. Find the unit shut-off and confirm which fixtures it controls.
  2. Inspect the failed fixture and any parts that wear with it.
  3. Repair or replace, using commercial-grade parts where the use is heavy.
  4. Test the fixture through several cycles.
  5. Note any other wear we saw so you can plan, with no pressure to act today.

Water heaters in small units

Many retail units run a small electric tank in a closet or above a ceiling. Those tanks often sit without a drain pan, and a failure can soak the unit below. We check the relief valve discharge, the pan and the shut-off, and we will say plainly if the tank is close to worn out.

Working with landlords and tenants

  • We confirm who authorises the work before we start
  • Notes are written so either party can read them
  • Shared-line problems are flagged to the property manager

From our call log

Can you fix a washroom without closing the store?

Usually yes. Most fixture repairs isolate one fixture and leave the rest in service.

How a visit runs

  1. 1

    Call

    Describe the fixture, the floor and how old the building is.

  2. 2

    Look

    We pull the trap, the cleanout plug or the access panel before any price is given.

  3. 3

    Explain

    You hear what failed and what we would replace, in plain words.

  4. 4

    Fix

    Water off, old part out, new part in, joints supported.

  5. 5

    Test

    Full flow or full pressure, every joint checked dry.

Water on the floor right now?

Turn the main shut-off clockwise and ring (365) 517-7959.

Call (365) 517-7959
Call (365) 517-7959